Sony SRG-XP1 Operating Instructions Manual page 50

[Auto2]: Eliminating the influences caused
by environmental illumination or
lights, automatically adjusts the color
reproduction closer to the original
color of the object (approximately
2000 K to 10000 K).
[Indoor]: Set a white balance suitable for
indoor photography.
[Outdoor]: Set a white balance suitable for
outdoor photography.
[One push WB]: Select to enable [One push
trigger].
[Sodium Lamp]: Adjust the appropriate
white balance for shooting under
sodium lamps.
[Manual]: Set [R gain] and [B gain]. Select
gain values from 0 to 128.
[One push trigger] (COLOR - ONE PUSH
TRIGGER)
Click [On] to adjust the white balance. Shoot
and zoom a large white object in the center
of the screen before adjustment.
[R gain] (COLOR - R.GAIN)
White balance can be manually adjusted in a
range from 0 to 128.
This setting is enabled only when [Mode] is
set to [Manual].
[B gain] (COLOR - B.GAIN)
White balance can be manually adjusted in a
range from 0 to 128.
This setting is enabled only when [Mode] is
set to [Manual].
[Color matrix]
[Enable] (COLOR - MATRIX)
Enables the color matrix setting.
[Saturation] (COLOR - LEVEL)
Adjust the color density of the image. Select
a value from [0] to [15]. The higher the value,
the darker the color and the smaller the
value, the lighter the color. This setting is
available when the checkbox of [Enable] is
selected.
[Hue] (COLOR - PHASE)
Adjust the color tone of the entire video.
Select a value from [0] to [15]. This setting is
available when the checkbox of [Enable] is
selected.
[Detail]
Select the sharpness.
[Level] (DETAIL - LEVEL)
The higher the value, the sharper the image.
The lower the value, the softer the image.
Select a value from [0] to [14].
[Gamma]
[Gamma] (GAMMA - SELECT)
You can select the type of basic curve for
GAMMA correction.
SRG-XP1:
[0]: Darker and contrast is clear.
[1]: Darker.
[2]: Contrast is clear.
[3]: Standard setting.
SRG-XB25:
[0]: Brighter.
[1]: Darker.
[2]: Contrast is clear.
[3]: Standard setting.
[Brightness]
Select a value from [0] to [15] to adjust the
brightness.
The higher the number, the higher the
brightness.
[Picture]
[2D NR level] (PICTURE - 2D NR LEVEL)
Select from [Off] or level [1] through level [3]
for noise reduction.
[3D NR level] (PICTURE - 3D NR LEVEL)
Select from [Off] or level [1] through level [3]
for noise reduction.
[Flicker cancel] (PICTURE - FLICKER
CANCEL)
Select from [Off], [50Hz], or [60Hz] for the
flicker correction function.
Note
Depending on conditions such as the type of
illumination and shutter speed, the flicker
correction feature may not be effective.
If the shooting frame rate is close to the
power supply frequency, the flicker
correction feature may not be able to fully
remove flickers even when it is enabled. If
this happens, adjust the shutter speed.
We recommend you set [Flicker cancel] to
[Off] when shooting under lights where no
flicker is generated, such as outdoors.
50