Operations Using The Supplied; Infrared Remote Commander; (Srg-Xp1 Only); Before Starting Operations - Sony SRG-XP1 Operating Instructions Manual

Operations Using the Supplied

Infrared Remote Commander

(SRG-XP1 only)

Before Starting
Operations
Before operating, check that the camera and
peripheral devices are properly installed and
connected.
For details, see "Installing the Camera" (page 16)
and "Connecting the Camera" (page 18).

Turning on the Power

AC adapter (supplied)
1
Connect the camera to an AC outlet using
the supplied AC adapter and power cord.
Or, connect the powered PoE power supply
device and the camera with a LAN cable.
The power is turned on and the POWER lamp
turns green.
2
Turn on the peripheral devices.
If the POWER button on the remote
commander is pressed while the camera is
turned on, the camera goes into the standby
mode.
Note
Wait at least 10 seconds if you want to turn on
the camera again after putting it in the standby
mode.
POWER lights

Pan/Tilt Operation

Notes
• When [Video out] > [Resolution] is set to
3840×2160/59.94p or 50p and [Output source]
is set to [HDMI+Stream], operation is not
supported.
• Pan and tilt operation is supported only when
using digital zoom.
1
Press the POWER button.
The camera will turn on and perform the
pan/tilt reset action automatically.
2
Press an arrow button to pan or tilt the
camera.
While checking the picture on the screen,
press the appropriate arrow button.
To move the camera little by little, press the
button just for a moment.
To move the camera in a wide range, press
and hold the button.
To move the camera diagonally, press the 
or  button while holding down the  or 
button.
To face the camera back to the front
Press the HOME button.
22