Sony SRG-XP1 Operating Instructions Manual page 12

The selected setting menu is displayed by
pressing the HOME button when the main
menu is displayed.
Notes
• When [Video out] > [Resolution] is set to
3840×2160/59.94p or 50p and [Output
source] is set to [HDMI+Stream], operation
is not supported.
• Pan and tilt operation is supported only
when using digital zoom.
 L/R DIRECTION SET button
Hold down this button and press the REV
button to change the direction of the camera
movement to be opposite the direction of
the arrows on the  and  buttons. To reset
the direction of the camera movement, press
the STD button while holding down this
button.
 POWER button
Press this button to turn on power on the
SRG-XP1 or to put the camera in standby
mode.
 BACK LIGHT button
Press this button to enable backlight
compensation. Press it again to disable
backlight compensation.
Note
The BACK LIGHT button is enabled when
MODE (Exposure mode) on the EXPOSURE
menu is set to [FULL AUTO] (Full auto) or
[SHUTTER Pri] (Shutter priority).
 POSITION buttons
Hold down the PRESET button and press
button 1 to 6 to store the current camera
direction, zoom, and backlight
compensation in the memory of the pressed
number button.
To erase the memory contents, hold down
the RESET button and press button 1 to 6.
Notes
• These buttons do not function when the
menu is displayed.
• Some memory contents may not be erased
even if you use the RESET button.
For details on items that can be stored by
the PRESET button and erased by the
RESET button, see "Preset Items"
(page 64).
 PAN-TILT RESET button
Press this button to reset the pan/tilt
position.
Notes
• When [Video out] > [Resolution] is set to
3840×2160/59.94p or 50p and [Output
source] is set to [HDMI+Stream], operation
is not supported.
• Pan and tilt operation is supported only
when using digital zoom.
 ZOOM buttons
Use the SLOW button to zoom slowly, and
the FAST button to zoom quickly.
Press the T (telephoto) side of the button to
zoom in, and the W (wide angle) side to
zoom out.
Note
When [Video out] > [Resolution] is set to
3840×2160/59.94p or 50p and [Output
source] is set to [HDMI+Stream], operation is
not supported.
Installing batteries in the remote
commander
Required batteries
Two R6 (size AA) batteries are required for the
remote commander. To avoid the risk of
explosion, use R6 (size AA) manganese or
alkaline batteries.
Note
Danger of explosion if the batteries are
incorrectly replaced. Replace only with the same
or equivalent type recommended by the
manufacturer. When you dispose of the
batteries, you must obey the laws of your area or
country.
R6 (size AA) batteries are not supplied.
12
Two R6 (size AA) batteries
(commercially available)