Storing The Camera Settings In Memory - Preset Feature; Storing The Camera Status; Recalling Stored Status; Clearing The Preset Memory - Sony BRC-X1000/H800 Operation Instructions Manual

Storing the Camera
Settings in Memory
– Preset Feature
Settings, including the camera position, zoom, focus,
and backlighting, can be stored in a preset.
Note
The camera supports 100 position presets. The number
of positions that are supported will vary depending on
the device used.
- For the RM-IP500 (sold separately), up to
100 positions.
- For the RM-IP10 (sold separately), up to 16 positions.
- For the remote commander (supplied), up to
6 positions.
For details on the camera settings that can be preset, see
"Preset Items" (page 58).
4
PRESET
3

Storing the camera status

1
Set PRESET MODE in the SYSTEM menu to
MODE1 or MODE2.
2
Press the PAN-TILT RESET button to reset
the pan/ tilt position.
3
Adjust the position, zoom, and focus of the
camera. (See pages 46 and 47.)
4
Hold down the PRESET button and press
any of the POSITION buttons, 1 to 6, in
which you want to store the settings.
3
4
POSITION 1~6
RESET
2
DATA SCREEN
While holding down
Note
Before you store the position, zoom, focus, etc. of the
camera, make sure to install and secure the camera in
place to use it properly. If you change the installation of
the camera after storing the settings, differences may
occur in the settings.

Recalling stored status

Press any of the POSITION 1 to 6 buttons in which you
have stored the settings.

Clearing the preset memory

Hold down the RESET button and press the desired
POSITION button from buttons 1 to 6 for which you
want to clear the settings.
DATA SCREEN
While holding down
Notes
• If you want to retain the previous pan and tilt positions
when the power is turned off and turned on again,
store those positions in POSITION 1. When PRESET
MODE is set to TRACE, the camera does not move to
the trace start position when the power is turned on.
• Storing or clearing the settings in POSITION 1 takes
about two seconds longer than for other positions.
• When you are storing or clearing the settings in one
POSITION, you cannot restore, store or clear the
settings in another POSITION.
• For details on the items that can be cleared from the
memory, see page 58.
• When PRESET MODE is set to MODE2 in the
SYSTEM menu, only the pan/tilt, zoom, and focus
positions of the camera are recalled.
48
BACK LIGHT
STD REV
1 2 3
Press the
4 5 6
POSITION
PRESET RESET
button you want
POSITION
to set.
BACK LIGHT
Press the
STD REV
POSITION
1 2 3
button you want
4 5 6
to clear.
PRESET RESET
POSITION