Table of Contents
Advertisement
• Always ground (earth) the luminaire electrically.
• Use only a source of AC power that complies with local building and
electrical codes and has both overload and ground (earth) fault protection.
• Ensure that the AC power distribution system includes a means of
isolating all installed devices from power and locking out power during
service.
• Ensure that all components in the AC power distribution circuits (cables,
junction boxes, etc.) are protected from water and airborne particles to
IP67 or higher, are suitably dimensioned for the current and power
requirements of the devices installed, and are of suitable type for the
location (including water, pollution, temperature and UV resistance).
• Do not expose the luminaire to a high-pressure water jet.
• Do not immerse the luminaire in water or install it in a location where
flooding may occur.
• Refer all service not described in this manual to a Martin service
technician.
Protection from burns and fire
• Do not operate the luminaire if the ambient temperature (T
C (104° F).
• Keep flammable materials well away from the luminaire.
• Allow the luminaire to cool for 15 minutes before servicing.
• Do not attempt to bypass thermostatic switches or fuses. Replace
defective fuses with ones of the specified type and rating only.
• Do not modify the luminaire. Install only genuine Martin parts and
approved fluorescent tubes of the type and wattage specified for the
armature.
• Provide a minimum clearance of 25 mm (1 inch) and unobstructed airflow
around the luminaire.
• Do not mask or modify light output with filters or other materials.
Protection from injury due to falls
• Block access below the work area and work from a stable platform
whenever installing, servicing or removing the luminaire.
• Ensure that all supporting structures, surfaces, fasteners and lifting
equipment can bear the weight of all the devices they are intended to
support plus an adequate safety margin, and that they conform to local
building and safety regulations.
• Use fasteners that have sufficient corrosion resistance, dimensions and
strength to mount the luminaire safely. Any nuts used must be self-
locking.
• Ensure that all components and installation fittings are securely fastened.
4
Cyclo IP65 Directional user manual
) exceeds 40°
a
Advertisement
Table of Contents
