Stand-Alone Operation - Martin Cyclo Directional IP65 User Manual

Stand-alone operation

DANGER! Read "Safety information" on page 3 before attempting to
operate this product!
In stand-alone operation, the Cyclo IP65 Directional can run light shows
without a DMX controller. Luminaires can be programmed to change colors
in cycles. Changes can be programmed at 1, 5, 10 or 30 second intervals.
Two stand-alone operation modes are available:
• In single stand-alone operation, luminaires run independently of each
other. No data link is required.
• In master/slave stand-alone operation, luminaires must be linked with a
serial data link ("Linking luminaires for DMX and synchronized operation"
on page 21 explains how to install this link). Synchronized action in all
luminaires is triggered by one "master" luminaire.
In both single and master/slave stand-alone operation, luminaires are
programmed by setting the pins on the DIP switch on the circuit board as
shown in the following table.
Pin Function
1 White active (04 models), red active (03 models)
2 Red active (04 models), green active (03 models
3 Green active (04 models), blue active (03 models)
4 Blue active (04 models)
5 & 6 Program speed
Pin 6
OFF
OFF
ON
ON
7 OFF = Blackout fading, ON = Crossfading
8 OFF = Run program, ON = Deactivate program (Note: always set to OFF)
9 OFF = Master, ON = Slave (Note: do not set more than one luminaire as master)
10 ON = Stand-alone mode.
Pin 5
OFF
ON
OFF
ON
Table 3. Stand-alone DIP switch settings
Stand-alone operation
Speed
1 sec. steps (fastest setting)
5 sec. steps
10 sec. steps
30 sec. steps (slowest setting)
29