Martin Cyclo Directional IP65 User Manual page 13

Adjust ing the support arm angle
To adjust the angle of the support arms in the base module:
1. Ensure that the luminaire is securely mounted and isolated from power.
2. Open the connections compartment as described in "Access to
connections compartment" on page 10.
3. See Figure 6. Support the weight of the tube module. Loosen the arm
adjustment screws at both ends of the base module with a long Allen key,
tilt the arms to the desired angle and retighten slowly, rocking the tube
module up and down slightly while you tighten so that the adjustment
screws engage correctly in the cutouts in the arm.
Figure 6: Arm-to-base adjustment screws
4. Reinstall the connections compartment cover as described in "Access to
connections compartment" on page 10.
3mm
Installation 13