Related Manuals for Ingersoll-Rand QS1P Series
Summary of Contents for Ingersoll-Rand QS1P Series
- Page 1 16575185 Edition 3 October 2013 Air Screwdrivers QS1P Series Maintenance Information Save These Instructions...
- Page 2 Product Safety Information WARNING • Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product.
- Page 3 7. If the Clutch Housing Bearing (76) is worn and must be replaced, 8. Using a hooked tool, reach into the opening in the end of the press it from the Clutch Housing. Clutch Shaft and carefully pull the Automatic Shutoff Plunger 8.
- Page 4 Assembly General Instructions Measurement of Front End Plate Clearance 1. Always press on the inner ring of a ball-type bearing when Pressure installing the bearing on a shaft. 2. Always press on the outer ring of a ball-type bearing when pressing the bearing into a bearing recess.
- Page 5 10. For Series QS1P28, lubricate the Planet Gear Head Drive 10. Lay a bead of Ingersoll Rand No. 28 Grease, approximately Plate (31) with Ingersoll Rand No. 67 Grease and install it 2 to 3 cc, on top of the Clutch Balls and then bring the Clutch on the shafts of the Planet Gear Frame Assembly.
- Page 6 Needle Bearing Inserting Tool 22. Thread the Inlet Bushing Assembly through the Diffuser and Back Cap into the Motor Housing. Using a 1-3/16” wrench on the flats of the Back Cap to keep it from turning, tighten the Inlet Bushing between 15 and 20 ft.-lbs.
-
Page 7: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Loss of Power Check air supply. For top performance, the air pressure must be Low air pressure 90 psig (6.2 bar/620 kPa) at the inlet. Clean the Inlet Bushing Screen using a clean, suitable cleaning Plugged Inlet Bushing Screen solution. - Page 8 ingersollrandproducts.com © 2013 Ingersoll Rand...