Table of Contents
Advertisement
Bosch Motorsport
13 Firmware
C 60 holds 4 types of data:
– Firmware: the software (PST program file) of the C 60.
– Configuration: the configuration of Input channels, CAN I/O, PWM, display configura-
tion, recording + telemetry configuration.
– Calibration data: Characteristic curves and offsets created by online calibration at the
vehicle.
– Recorded data: Measurement data recorded during vehicle operation.
Firmware update
The scheme shows the process during each connection between RaceCon and C 60. Firm-
ware update is only possible if the C 60 is connected to RaceCon. The configuration of In-
put channels, CAN I/O, display, recording + telemetry will not be changed.
1.
In the C 60 Project Tree, right-click on 'C 60' and choose 'Synchronize' then 'Update
firmware'. A pop-up menu opens.
2.
Select the destination of the firmware archive (PST).
3.
Click 'OK' when done. The firmware update starts. The C 60 displays the message 'Up-
dating firmware'. Do not switch off the car's ignition or interrupt the power supply of
theC 60! When the firmware update is complete, the C 60 displays the message 'Up-
dating firmware finished. Do a powercycle.'
4.
Switch the car's ignition off and on again to cycle the power of theC 60.
Data_Logger_C_60_Manual
Firmware | 13
89 / 100
Advertisement
Table of Contents
