Table of Contents
Advertisement
10 | Online Measurement and Calibration
10.2.2 Performing the online offset calibration
64 / 100
In the channel view
C 60 has to be connected to RaceCon to calibrate the sensor's offset.
1.
Apply the desired physical condition to the sensor (e.g. 1 G to an acceleration sensor).
2.
Open the measurement channel's online page by double-clicking on the measure-
ment channel name in the Data Area.
3.
Enter the physical target value (e.g. 1 G) and press the 'Calibrate' button.
Calibration
target value
Initiate
calibration
The sensor's offset is now calibrated.
Data_Logger_C_60_Manual
Check box to enable online
offset calibration and enter
desired physical target value
Activate switch
to enable online
calibration
Bosch Motorsport
Advertisement
Table of Contents
