Lap Timing - Bosch C60 Manual

12 | Lap Trigger

12.3 Lap timing

82 / 100
– Global start condition fulfilled: recording starts
– Reception of valid lap trigger: recording of lap completed, new lap starts
– Power OFF or Global start condition not fulfilled: recording of lap completed, system
shutdown
The system is counting:
Outing:
– The outing counter is incremented with each power cycle when at least one valid lap
(not by forced lap trigger) was recorded
Lap:
– Leaving the pits to lap trigger
– Lap trigger to lap trigger
– Enforced lap trigger (see Distance based forced trigger [} 84])
Fragment:
– Test bench operation
– Power cycle on track or box (e.g. engine stalled)
– File fragmentation size [MB], time [sec]
Channels for display
To display counters use the following channels:
Channel
Laptrigger_outcnt_dls
Laptrigger_lapctr_dls
Fractr
Counting in WinDarab
To automatically name recorded files use filename templates in WinDarab dialog:
Filename template
[outing]
[lap]
[fragment]
[###03] indicates: 'always use 3 digits with leading zeros'.
There are different possibilities to adjust the lap trigger to the timing situation.
The detection time defines the minimum time the input signal changes its state. E.g. a low
active signal needs to be below the threshold for min. 15 ms to release the trigger.
Channels for display
To display lap times use the following channels:
Channel
Laptrigger_lapctr_dls
Data_Logger_C_60_Manual
Function
Outing counter
Lap counter
Fragment counter
Function
Value of outing counter
Value of lap counter
Value of fragment counter
Function
Number of completed laps
Bosch Motorsport