Related Manuals for MadgeTech RFOT
Summary of Contents for MadgeTech RFOT
-
Page 1: Table Of Contents
RFOT Wireless Meat Temperature Data Logger PRODUCT USER GUIDE To view the full MadgeTech product line, visit our website at madgetech.com. TABLE OF CONTENTS 2 Quick Start Steps 2 Product Overview 3 Software Installation 4 Activating & Deploying the Data Logger... -
Page 2: Quick Start Steps
The RFOT is shipped with wireless transmission in an active, low power state. During normal use, inserting a USB (micro B type) cable into the RFOT will pass control to the MT4 software and disable the wireless transmission. When the USB cable is unplugged, wireless transmission resumes with settings that were chosen in MT4. -
Page 3: Software Installation
2. Locate and unzip the downloaded file (typically you can do this by right clicking on the file and selecting Extract). 3. Open the MTInstaller.exe file. 4. You will be prompted to select a language, then follow the instructions provided in the MadgeTech 4 Setup Wizard to finish the MadgeTech 4 Software installation. -
Page 4: Activating & Deploying The Data Logger
3. Launch the MadgeTech 4 Software. the wireless signal. 4. The RFOT is shipped with wireless transmission in an active, low power state. Inserting a USB (micro B type) Transmission Distance cable into the RFOT enables direct USB communication Typical transmission distance and disables wireless transmission. -
Page 5: Channel Programming
Different wireless channels may be used to create multiple networks in one area, or to avoid wireless interference from other devices. Any MadgeTech data logger or RFC1000 wireless transceiver that is on the same network is required to use the same channel. If all of the devices are not on the same channel, the devices will not communicate with one another. - Page 6 Materials: TLH-5903 Battery O-Ring maintenance is a key factor when properly caring for the RFOT. The O-Rings ensure a tight seal and prevent 1. Unscrew the end cap from the RFOT to expose the liquid from entering the inside of the device. Please refer O-Ring.
- Page 7 TROUBLESHOOTING Why is the wireless data logger not appearing in the software? If the RFOT doesn’t appear in the Connected Devices panel, or an error message is received while using the RFOT, try the following: • Check that the RFC1000 is properly connected. For more information, see Troubleshooting wireless transceiver problems (below).
- Page 8 RFOT COMPLIANCE INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 9 • Refer to the Troubleshooting section of this document. • Visit our Knowledge Base online at madgetech.com/resources. • Contact our friendly Customer Support Team at (603) 456-2011 or support@madgetech.com. MadgeTech 4 Software Support: • Refer to the built-in help section of the MadgeTech 4 Software.