Advertisement
10-3 M2504 VIDEO INVERTER
In t h i s position (lower), the output video signal i s inverted with regard
to input intensity as indicated below.
The VIDEO INVERTER option comes completely adjusted and ready f o r use.
Installation
I. Turn P O W E R switch OFF on the CCU.
2. Unplug the CCU power supply cord.
3. Using a small Phillips screwdriver, loosen the 4 screws on the side
of the CCU and remove the cover.
4. Insert the H2504 option card i n t o the connector labeled JC INVERTER
as i l l u s t r a t e d i n the figure below.
5. Replace the CCU cover making sure that the a i r vent i s located on the
left and tighten the 4 holding screws.
—32—
'
Advertisement
