TA Instruments TGA 2050 Operator's Manual page 31

TA I TGA 2050
NSTRUMENTS
Unpacking/Repacking the 2050
5. While your assistant holds the unit, use a
wrench to remove the two nuts and washers
from the bottom. Then lift and rotate the
unit so that the other end hangs over the
edge of the bench. Someone must hold
onto the unit at all times while it is in this
position. While your assistant holds the
unit, remove the two nuts and washers from
the other side.
6. Slide the unit completely onto the lab bench.
Have your assistant hold one side up while
you unscrew and remove the black rubber
shipping feet from the bottom. Then rotate
the unit and remove the shipping feet from
the other side in the same manner.
7. Have your assistant lift one side of the unit
while you install two mounting feet on one
side (see Figure 2.3). Screw in about 1/4-
inch of the threaded mounting post into the
unit. Rotate the unit and install the two
remaining mounting feet on the unit in the
same manner.
8. Have your assistant lift the entire unit while
you slide the plywood board out from under
the unit.
9. Turn the instrument to face front and use a
wrench to remove the furnace clamp from
the unit. Retain this clamp in case the
instrument needs to be shipped in the future.
2–5