Tecnosicurezza MiniTech User Operating Instructions page 3

To adjust keypad contrast
Press and hold 8.
The keypad firmware version and release date will
display. Press and hold 8 again.
Select the desired contrast level, then
To download or view the audit (Manager or Master)
Manager: Press and hold 7. Enter the Manager code.
Master: Press and hold
scroll to SYSTEM AUDIT, press
If the audit is to be downloaded either to a Dallas
key or directly to a PC, please refer to MiniTech
Audit Instructions.
If the audit events (Lock opening and closing only) are
to be viewed on the MiniTech Display.
Press . Press then
each event. Press to exit.
To add time delay values
Press and hold 9. Enter the Manager code.
The display will show the current time delay values.
Press
Enter time delay value e.g. 01 minute (Max. 99 minutes)
Enter open window value e.g. 01 minutes (The
minimum open window value is 01, the maximum is 19).
Press to accept
Note: If the time delay values are to be reduced, the lock must first be
unlocked during the open window and the bolt must be held in the
open position before again accessing the time delay menu.
To access the Master Menu
Press and hold . Enter the master code.
To adjust time and date (Master Only)
Access the Master menu, scroll to TIME AND DATE
SETTINGS.
Press to view the time and date.
Press again to enter new values.
Press to accept.
Note: The time and date cannot be adjusted when
timelock is active.
To turn off Automatic DST (Master Only)
Summer and wintertime DST changes are programmed
into the lock system by the manufacturer. The values
can be updated using software or disabled through the
keypad.
The bolt must first be in the open position. Access the
Master menu, scroll to AUTOMATIC DST, Press
Press to scroll to OFF? then
to accept
, enter the Master code,
to accept
again to scroll through
to accept.
Timelock: Adjust weekly timelock (Master Only)
A weekly schedule can be entered to specify periods of
time when the lock can be opened by users (open
periods) or cannot be opened by users (timelock
active).
Warning: The timelock menu is only accessible during
open periods. The values entered are the open periods:
Ensure that values are entered for every applicable
day before saving all values and exiting the weekly
timelock settings menu.
Access the Master menu, scroll to TIMELOCK
SETTING, press
Scroll to WEEKLY TIMELOCK SETTING. Press
accept. Scroll to ADD NEW VALUES, press
accept
Press to scroll through the days.
Enter the start and end times of the open period, then
to accept.
Press to scroll through the days to add additional
open periods. Each day will autocomplete with the
same times as the previous entry, but can be
overwritten. Each day's values are only be saved if
is pressed.
Once each day has been scrolled, to save the complete
schedule press
LIST EXIT AND SAVE?
Scroll to VERIFY OR DELETE VALUES to check each
day. If required, press
to accept. Do not exit the weekly timelock menu
until all correct open period values are saved to
avoid the risk of lock out.
Timelock: Adjust closing periods (Master Only)
Closing periods are occasions when the safe would
normally have a timelock open period, but is required to
be inaccessible. E.g. the lock would normally have an
open period of 09:00 to 17:00 on Mondays, but a
closing period is required for a public holiday.
Access the Master menu, scroll to TIMELOCK
SETTING. Scroll to CLOSING PERIODS SETTING.
Press to accept. The options available are:
ADD NEW VALUES / VERIFY OR DELETE VALUES
Select ADD NEW VALUES and enter the dates and
times required. Up to 30 closing periods for a maximum
of 14 days each can be held in the lock memory.
If a closing period should repeat each year, press
instead of inputting the year.
.
to accept.
when the display shows END OF
to delete open periods, then
to
to