17 May, 1999
6.6.9 BY-PASS FEED PAPER WIDTH SENSOR REMOVAL
Preparation
1) Remove the by-pass tray (Refer to By-pass Tray Removal, section 6.6.8.).
[A]
A250R717.WMF
1. Remove the tray lever [A] (1 snap ring and 1 pin).
2. Remove the upper by-pass tray [B] (1 mylar and 2 hooks).
3. Replace the by-pass feed paper width sensor [C].
NOTE: 1) Be sure to unhook the hooks or they may break.
2) When reinstalling the by-pass feed paper width sensor, move the paper
guides to the center position.
Adjust the position of the hole in the sensor gear as shown when
installing the paper width sensor.
[B]
[C]
6-31
PAPER FEED
A250R718.WMF