Denso Movincool CLIMATE PRO K60 Service Manual page 61

Removal of Communication Module
5. Battery Removal and Installation
Battery Specification
Note:
Before disconnecting the battery, place the battery switch to "OFF" position.
(See section 6, Set Communication Module to Operate by Internal Battery)
a) Remove two screws from battery cover.
b) Disconnect battery connector by pressing
connector tab and pulling battery
connector from the connector socket
inside the module.
c) To install battery, insert battery
connector into the connector socket until
it clicks to ensure proper connection.
d) Place battery in the hollow space and
ensure battery wires are in place. Insert
the two pins of battery cover into
housing then close the cover and secure
with the two screws.
Model
Nominal Voltage
Nominal Capacity
61
SC-04002-02
3.7V
2500 mAh
Battery
Battery
Hollow Space
Battery
Connector
Battery
Connector
Connector
Socket