Radar sensor for continuous level measurement (30 pages)
Summary of Contents for BINMASTER NCR-80
Page 1
Quick Setup Guide Radar sensor for continuous level measurement of bulk solids NCR-80 4-20 mA/HART–four-wire www.binmaster.com...
Page 2
Mounting Mounting preparations, mounting strap The strap is supplied unassembled and must be attached to the sensor before setup with three hexagon screws M5 x 10 and spring washers. Required tools: Allen wrench size 4. There are two ways to attach the strap onto the sensor. Depending on the selected version, the sensor can be swivelled in the strap as follows: •...
Page 3
Connecting to power supply Connection The voltage supply and signal output are connected via the spring loaded terminals in the housing. Connection to the display and adjustment module or to the interface adapter is carried out via contact pins in the housing. Connection procedure 1.
Page 4
Wiring plan, double chamber housing Connection compartment with mains voltage Terminal Function Polarity Voltage supply Voltage supply 4–20 mA output (active) 4–20 mA output (passive) Mass - output Function ground with installation according to Fig. 4: Connection compartment with double chamber housing with mains voltage Connection compartment with low voltage Terminal Function...
Page 5
1. Unscrew the housing cover. 2. Place the BinDisc display and adjustment module on the electronics in the desired position and turn it to the right until it snaps in place. 3. Screw housing cover with inspection window tightly back on. Disassembly is carried out in reverse order.
Page 6
3. Application/Vessel bottom Specify the application and the form of the vessel bottom. 4. Vessel height/Measuring range Enter the height of the vessel and the active measuring range. 5. Max. adjustment Enter the measuring distance for 100% filling. 6. Min. adjustment Enter the measuring distance for 0% filling.
Page 7
The product level during this adjustment is not important because the min./max. adjustment is always carried out without changing the product level. These settings can be made ahead of time without the instrument having to be installed. Diagnostics - Echo curve memory The function “Setup”...
Page 8
Operating voltage - Version for low voltage 9.6–48 V DC, 20–42 V AC, 50/60 Hz - Version for mains voltage 90–253 V AC, 50/60 Hz Reverse voltage protection Integrated Max. power consumption 4 VA; 2.1 W MANUAL NCR-80 QUICK START 925-0349...
Need help?
Do you have a question about the NCR-80 and is the answer not in the manual?
Questions and answers