Status Screen - Graco PD44 Setup And Operation

HMI Operation

Status Screen

NOTE: A "1" indicates that the button is in the "ON" posi-
tion. A "0" indicates that the button is in the "OFF" posi-
tion.
NOTE: The Error Code button is shown on every screen
on the Motor Driven PD44. See the Main screen for defi-
nition, page 16.
Maintenance Totalizer
This counter increments each time the machine cycles.
Press the Reset Maintenance Totalizer button to reset.
This counter is used for maintenance purposes.
# Of Times Maintenance Totalizer has been Reset
This counter increments each time the Reset Mainte-
nance Totalizer button is pressed.
Reset Maintenance Totalizer button
This button resets the Maintenance Totalizer.
Cycle Totalizer
This counter increments each time the machine cycles.
Number of Strokes (Motor Driven PD44 Only, not
shown)
This displays the number of strokes needed to perform
the currently selected shot size. If the selected shot size
is 150%, Number of Strokes displays a "2".
28
Micrometer PD44 and LRT PD44 Status Screen Shown
Amount per Stroke in % (Motor Driven PD44 Only,
not shown)
This displays the amount of stroke used to perform the
currently selected shot. If the shot size is 150%, Amount
per Stroke in % displays "75%".
Dispense Ready
This displays "1" if the metering rods are loaded with
material and ready to dispense. It displays a "0" if the
metering tube is reloading or at the end of the dispense
cycle. Customer Signal Integration Kit 80/2450/CS/50,
which uses this output, can be ordered separately. The
Customer Signal Integration Kit is standard on Motor
Driven PD44s.
313877G