Omega OSD607X Instruction Manual page 34

Troubleshooting Tips
Problem
Wash items are not fully
dry
Glassware developing
cloudy stains and calcium
rings
Wash items showing signs
of rust
Tub becoming dull in color
Traces of detergent in the
tub
Foam in the wash tub
Error Codes
If there is a malfunction, the dishwasher will display error codes to identify the symptom.
Codes
E1
E3
E4
Ec
Ed
EH
Possible Causes
Unloading dishwasher too soon.
Insufficient Rinse Aid.
Rinse Aid setting too low.
Insufficient Rinse Aid being
dispensed.
Items are unsuitable for
dishwasher use.
Tub requires rejuvenation.
Incomplete/interrupted wash cycle.
Non electric dishwasher detergent
used.
Spilt Rinse Aid present.
Meanings
Extended Water Inlet Time.
Water temperature not reaching
target.
Leak Detected.
Washing Control System failure.
Failure of connection between
Display Unit and the Control
System.
The cover does not open or close
properly.
34
What To Do
The drying cycle must be complete
before the dishwasher is unloaded.
Check the Display for end time.
Check for Low Rinse Aid Level
warning and re fill if necessary.
Increase Rinse Aid setting.
Adjust the Rinse Aid Dispenser as
per the instructions
Discontinue washing such items in
the dishwasher.
Dose the tub with specific Stainless
Steel Tub /Bowl Cleaner.
Rerun wash program to ensure
wash load is not contaminated with
detergent.
Use correct detergent.
Repeat the Rinse Program until
clear.
Possible Causes
Water supply failure, closed faucet,
or insufficient supply water
pressure.
Heating element malfunction.
For some reason water has leaked
from the wash system. Possibilities
are over height item in the wash
load stopping lid from sealing;
internal plumbing or seal failure.
Electronics or Motor failure.
Wiring failure between the two
devices.
The cover motor device damage or
foreign matter stuck.