Omega OSD607X Instruction Manual page 25

Operating Instructions
Undo the plug by turning it
anticlockwise.
Close the plug by rotating it clockwise.
Adjusting the rinse aid dispenser
To achieve the best drying result, with the least amount of rinse aid being used, the dispenser can be
adjusted by the user.
There are 5 levels of adjustment, the factory setting is D5. This setting will provide excellent drying results.
If the dishes are not drying properly or with cloudy stains, the setting of D4 or D5 will be required.
If there are sticky whitish stains on your dishes or a bluish film on glassware or knife blades, the dispenser
can be set back to either D2 or D1 to reduce any unnecessary waste of rinse aid, whilst maintaining
excellent drying results. Follow the steps below:
1. Switch on the dishwasher by pressing the Power button.
2. Within 60 seconds after step 1, press the Start/Pause button more than 5 seconds, the rinse aid
indication blinks.
3. Press the Start/Pause button to select the proper set according to your using habits, the sets will change
in the following sequence: D1->D2->D3->D4->D5->D1.
4. Without any operations in 5 second, or exit the set mode through the power button, the new
active.
Fill the dispenser slowly to avoid
spillage. Each dispenser will take
300ml from empty.
NOTE:
It is important to clean up any spills rinse aid, as it
will cause excessive foaming in the wash cycle.
25
setting is