7
Regulate the temperature in adjacent rooms via thermostatic
•
valves.
External heat in the room where th FR 10 is installed (e.g. solar
•
gain, stove etc.) can result in too little heating in adjacent
rooms (the heating system remains cold).
Much energy can be saved by reducing the room temperature
•
via economy phases. Reducing the room temperature by
1 K ( °C) enables up to 5% energy to be saved.
It is not recommended to let the room temperature of heated
rooms fall below +15 °C during the daytime, otherwise the
cooled-down walls continue to radiate cold and the room tem-
perature rises higher, leading to higher energy consumption
than if an even heat supply is applied.
Good thermal insulation of the building: The set temperature
•
for
energy is being saved as the heating system stays off.In that
case, switch sooner to the lower operating mode.
Don't keep windows slightly open for ventilation. This leads to
•
a constant extraction of heat from the room without noticeably
improving the ambient air in the room.
Vent briefly but intensively (open window fully).
•
During venting shut off thermostatic valves fully or switch the
•
operating mode to Frost.
very to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.c
Tips on saving energy
Economy or
6 720 617 760 (2008/09)
Frost is never reached. Nevertheless
Tips on saving energy
27