ResMed Mirage Activa Manual page 5

TIP!
You can detach the elbow from the mask frame while wearing the
mask (see "Disassembling For Cleaning"). This is useful when
therapy needs to be stopped for a short time; for example if you
need to go to the bathroom.
D
ISASSEMBLING
1 Detach the mask elbow. To do this, squeeze the raised dots
on the sides of the mask elbow while pulling it away from the
mask frame (Fig. C-1).
2 Disconnect and separate the main air tubing, short air tubing,
mask elbow and vent cover (Fig. C-2).
Notes
To prevent damage to the short air tubing, disconnect it by
•
holding it at the cuff.
The swivel does not need to be disconnected from the short air
•
tubing.
3 Squeeze the headgear clips to release them from the mask
frame. Unfasten the Velcro® straps and unthread the upper
headgear straps through the slots of the forehead support.
4 Remove the ports cap from the mask frame (Fig. C-3).
5 Detach the cushion assembly from the mask frame. To do
this, squeeze the two side latches on the cushion clip until
they disengage from the mask frame (Fig. C-4). Then pull the
mask cushion assembly out and away from the mask frame
(Fig. C-5).
6 Remove the cushion clip from the mask cushion. To do this,
roll back one end of the A
out (Fig. C-6).
7 Depress the forehead support tab and move it past the top
slot position (Fig. C-7). This allows you to remove the
forehead support from the mask frame.
F C
OR LEANING
C
and pull the cushion clip
CTIVE ELL
5