Riello ALUDOMUS SOLAR KV/200 20 ISC SOLAR User Manual page 17

− The display shows the system status and the
temperature measured by the boiler tempera-
ture sensor .
T
Press the key:
− With an outdoor temperature sensor connected
you can now set the room temperature setpoint
− With no outdoor temperature sensor connected
you can now set the central heating circuit tem-
perature setpoint.
+ -
Press the keys to adjust the setpoint.
Press any of the
R T M V
The new setting is stored in memory .
S
− Press the key .
+ -
− Press the
setpoint.
Press any of the
R T M V
The new setting is stored in memory .
9
If any boiler ignition or functioning errors are de-
tected, the display shows the type of error.
Errors can be of two types:
− PERMANENT errors are those that can only be
cancelled by pressing the
− TEMPORARY errors are those that are automati-
cally cancelled as soon as the cause is rectified
(see "Error codes").
9
If the safety thermostat trips, the PERMANENT "E110"
error appears on the display.
Proceed as follows to reset the safety thermostat:
− Wait until boiler temperature falls below 80°C
S
− Press the
key .
− The complete ignition cycle will be repeated up
to the ignition of the flame.
9
Any additional central heating zones must be con-
figured using the room unit (refer also to the in-
struction manuals supplied with the various acces-
sory kits).
keys to exit.
. keys to adjust the DHW
keys to exit.
S
key.
17
ENd USER