Riello ALUDOMUS SOLAR KV/200 20 ISC SOLAR User Manual page 12

ENd USER
Domestic hot water (DHW
Press the DHW key (1) to enable domestic hot water pro-
duction. A line appears under the DHW symbol.
ON
DHW is generated according to the DHW time program
(parameters 560 to 566).
OFF
DHW production is switched off but the protection fun-
ctions remain active.
9
You can force DHW production (PUSH function) by
pressing and holding the DHW key (1) for at least 3
seconds.
Setting the room temperature setpoint
Turn the knob (4) to set the desired room temperature
comfort setpoint.
Proceed in a similar way to set the room temperature
reduced setpoint:
− Press the "OK" key (6).
− Select "Heating circuit 1".
− Set the room temperature reduced setpoint.
9
After changing a setpoint, you need to wait about
2 hours for the new setting to have any effect on
room temperature.
9
If no room unit is installed, changing the room tem-
i
perature setpoint simply shifts the heating curve.
Information
Press the information key (8) to display:
− Errors or maintenance codes (see the "Errors/
Maintenance codes" section).
− Special messages.
Other screens:
9
Other screens depend on the system configuration
and status . Some of the info lines shown below
may not therefore appear.
− Room temperature
− Heating circuit 2 status (not active)
− Minimum room temperature
− Heating circuit P status
− Maximum room temperature
− dHW status
− Boiler temperature
− Boiler status
− Outdoor temperature
− Solar heating status
− Minimum outdoor temperature
− Solid fuel boiler status
− Maximum outdoor temperature
− Buffer storage tank status
− DHW 1 temperature
− date and time
− Heating circuit 1 status
− Telephone number of technical assistance centre
v
1
Boiler temperature
12
6
4
8