Table of Contents
Advertisement
4.3 Configuring Client+AP mode
Configuration procedure:
Before configuration, ensure that the upstream AP is connected to the internet successfully.
Assume that the upstream AP has the basic information described in the following table.
IP Address
SSID
192.168.0.254
Tenda_1
Step 1
Log in to the web UI of this AP, and change its IP address to an unused IP address
belonging to the same network segment as that of the upstream AP, such as
192.168.0.253. For details, refer to Section
Step 2
Use the new IP address to log in to the web UI of this AP, and choose Quick Setup.
Step 3
Set the Working Mode to Client+AP.
Step 4
Click Scan.
Step 5
Select the SSID of the upstream AP from the detected SSIDs, which is Tenda_1 in this
example.
If the AP detects no wireless network, choose Wireless > Basic to enable the wireless function, and
then try again.
Step 6
After you select an SSID, the SSID, Security Mode, Encryption Algorithm, and Upstream AP
Channel are populated automatically. You just need to enter the password of the wireless
network of the upstream AP in the Key box. Set Key to the wireless network password of
the upstream AP, which is 87654321 in this example.
Step 7
Click Save.
Security Mode
WPA2-PSK
Security Key (Wireless Network Password)
87654321
6.1 LAN
Setup.
14
Advertisement
Table of Contents
