MyTek Brooklyn ADC Owner's Manual page 16

16
8.2.5 Input Mode
• Unbal (unbalanced) – for unbalanced signal sources - solid state signal path
• Bal (balanced) – for balanced signal sources - solid state signal path
• T3:1, T2:1, T1:1 - transformer saturation level - nickel transformer is engaged in AD signal path.
For use with unbalanced sources shortening negative with ground on the connector is needed.
8.2.6 Mode (Device Mode)
Brooklyn DAC has two operating modes:
• ADC (standalone mode) device is connected to external devices via AES, SPDIF, SDIF or TOSLINK
connectors.
• PC (personal computer) when connected to computer via USB port.
8.2.7 Disp Auto Off
off. It is still possible to listen to music while the display is off. To return to the main
screen press any button on the frontpanel (including Vol knob).
8.2.8 Display Bright
display.
8.2.9 Diode Bright
8.2.10 St-by D Bright
Standby mode.
8.2.11 Colour
(Logo Colour) - Sets the colour of the logo, 16 colours are available.
8.2.12 Power On
• WORK - the ADC activates itself in standard working mode
• STBY – the ADC activates itself in standby mode
• AUTO – the ADC remembers last mode
8.2.13 Device
(Device Info)
• INFO- shows firmware version and unique serial number of the unit.
• RESTORE – restores to default factory settings.
Note! All above settings can also be
changed by using the Mytek Control
Panel application.
(Display Auto Off) - sets the interval when the display is turned
(Display Brightness) - this allows to adjust the brightness of the
(Diode Brightness) - sets the brightness of the logo (0 – 16 steps).
(Standby Diode Brightness) - sets the brightnes of the logo in
- (when the powerd cord it attached to the ADC)
Mytek Brooklyn ADC