Subscribe to Our Youtube Channel
Related Manuals for MyTek Stereo96 DAC
Summary of Contents for MyTek Stereo96 DAC
-
Page 1: User Manual
MASTERING DIGITAL TO ANALOG CONVERTER USER MANUAL VER.5/jan 2006 Use ver.7 manual for newer units (with toslink) -
Page 2: Table Of Contents
Http://www.mytekdigital.com Operation- Analog output alignment……………..………8 Operation- Unbalanced Output...…….......9 For technical support, technical tips and support check: Rack mount shelf........….....11 Http://www.mytekdigital.com/products/stereo96dac.htm Companion Stereo96 ADC……………………………..12 or contact Mytek tech support at: Specifications…………………………………………..13 info2007@mytekdigital.com Warranty conditions……………………………………..14 or at: tel. (646)-613 1822 fax.(212)-202 5331... -
Page 3: Quick Start
Sample rate selection. max. This is factory default. The Sets the desired The MYTEK Stereo96 series consists of two 1/3 rack units- the Stereo96 ADC knob can be disabled with internal sample rate. When and the Stereo 96 DAC. They are also a part of extended family of 1/3 rack jumpers. - Page 4 Stereo96DAC internal trimpots and jumper assignments Stereo96DAC internal trimpots and jumper assignments (remove top cover to access) (remove top cover to access) Internal analog output jumpers: JP2, JP4 - insert front stereo potentiometer as the output XLR volume control- default- used typically when power amp or powered speakers are connected to output.
- Page 5 In typical setup the DAC is running on its internal clock in Superlock (tm) RMS values. "0 VU"at + 4dB corresponds to 1.225 Volts RMS measured mode. In this mode Mytek DAC serves as a very stable low jitter clock between pin hot (2) and pin cold (3) at the output XLRs.
- Page 6 (see “alignment”). Typically the DAC is ran on its internal clock in Superclock (tm) mode. In this mode Mytek DAC serves as a very stable low jitter clock source which enables TOTAL jitter immunity which means that any jitter at the DAC digital in is completely removed.
-
Page 7: Rack Mount Shelf
The Stereo96 ADC is 1/3 rack space wide and 1U tall. Mytek provides a 1U rack mount shelf as accessory to mount up to 3 of 1/3 rack units. The units are attached to shelf with small screw connecting... -
Page 8: Specifications
All sample rates playback with 100-kHz analog Any faulty unit should be sent, shipping prepaid, to the manufacturer bandwidth in SuperLock(tm) mode service center. Prior to shipping the client should obtain from Mytek an RMA# for warranty services. Units sent without RMA# will not be Resolution: 24 bit (16-24 bit input accepted) accepted.
Need help?
Do you have a question about the Stereo96 DAC and is the answer not in the manual?
Questions and answers