Related Manuals for MyTek Stereo 192 ADC
Summary of Contents for MyTek Stereo 192 ADC
- Page 1 STEREO 192 ADC MYTEK DIGITAL.USA TRIMPOTS SWITCHABLE SWITCHABLE 88.2 SYNC /SUPERCK 176.4 TRIM 44.1 MASTERING ANALOG TO DIGITAL CONVERTER USER MANUAL VER. May 2006...
-
Page 2: Table Of Contents
Operation- Analog input alignment……………...………9 Operation- Unbalanced Signal Source…….......10 For technical support, technical tips and support check: Sampling frequencies and External synchronization…..12 http://www.mytekdigital.com/ Rack mount shelf........….....14 or contact Mytek tech support at: Companion Stereo Series Converters…………………..15 Info2006@mytekdigital.com Specifications…………………………………………..17 Warranty conditions……………………………………...18 or at: tel. -
Page 3: Introduction
Refer to "Alignement” wordclock. sample overload. for details. The MYTEK Stereo series is an extended family of 1/3 rack units which includes 96 and 192kHz capable converters, SRC and STEREO 192 ADC Studio Clock. Stereo192 converters can be used as stand-alone... - Page 4 Stereo192ADC internal trimpots and jumper assignments Stereo192ADC internal trimpots and jumper assignments (remove top cover to access) (remove top cover to access) Jumper JP5: Wordclock input 75 Ohm termination. Connect this jumper when Stereo96 ADC is the last destination in a chain fed by external wordclock source and the cable is long (above 6ft).
- Page 5 Mytek clock either through digital output 5. Synchronize the destination either to digital input sync or to wordclock signal or wordclock. In this configuration Mytek ADC serves as a very sync, depending on system configuration. The quality of recorded signal...
- Page 6 DAW. The wordclock source can be terminated with internal 75 Ohm resistor inside the Mytek unit (see: "Internal jumpers"). The termination is 2. Connect a digital PEAK meter to a digital output. If you don't have a...
-
Page 7: Sampling Frequencies And External Synchronization
Mytek clock either through digital output occasional overloads might be acceptable. signal or wordclock. In this configuration Mytek ADC serves as a very stable low jitter house clock which increases the integrity and robustness of the rest of the system. Because of careful design this clock is as good or better than dedicated studio clock generators. -
Page 8: Rack Mount Shelf
DSD. The Stereo96 ADC is 1/3 rack space wide and 1U tall. Mytek provides a 1U rack mount shelf as accessory to mount up to 3 of 96k sample rate, has in our opinion, a marginally better perceived sound 1/3 rack units. -
Page 9: Companion Stereo Series Converters
Companion Stereo Series Converters from Mytek this page will be updated... -
Page 10: Specifications
Any faulty unit should be sent, shipping prepaid, to the manufacturer Sample rates: 44.1, 48, 88.2, 176.4, 192kHz service center. Prior to shipping the client should obtain from Mytek an or wordclock 25-100kHz RMA# for warranty services. Units sent without RMA# will not be accepted.
Need help?
Do you have a question about the Stereo 192 ADC and is the answer not in the manual?
Questions and answers