MyTek BROOKLYN BRIDGE Quick Setup Manual

BROOKLYN BRIDGE
NETWORK QUICK SETUP GUIDE
The Brooklyn Bridge is a streaming device with D/A
and analog section inherited from our best selling
Mytek Brooklyn DAC+.
Follow these guidelines to enjoy your
favourite music collection.
Place the Brooklyn Bridge (aka BB) on flat and open surface.
Now you need to decide what network connection you want to use: wired via Ethernet cable or Wi-Fi 2.4G.
2
7 7
The following steps only apply to a Wi-Fi connection
4 Push a knob to go to menu screen
Find "Network" tile by turning a knob clockwise
5
Wait until "Network" tile is not greyed out
6
Select it via corresponding button
7
Turn a knob to select your local 2,4G Wi-Fi
8
Select connect tile on BB (4
9
Enter your Wi-Fi password
10
• Turn knob to change character on selected position
• Use arrows (1
st
position

CONNECTION

1 1 3
7 7 4
9 5
11 8
13
button)
th
& 2 buttons) to change cursor
nd
Connect Ethernet cable to the socket
1
or attach included Wi-Fi antenna
Optionally connect the BB outputs to your
2
system
Connect the BB to power outlet
3
– it will start automatically
If you connected Ethernet
cable please wait until
ethernet icon will show up
Done - you are connected to network
via Ethernet cable!
Select connect tile on BB (4
11
Wait up to one minute. You should see informa-
12
tion that the BB is connected to your network
Push a knob to exit to menu.
13
Wi-Fi icon will appear on the
screen and show quality of
your wireless connection
Done - you are connected to Wi-Fi!
button)
th