Table of Contents
Advertisement
Self-lest Menu (continued)
Controls Test Menu
CONTROLS TEST
Select CONTROLS TEST at the Self-Test Menu. The Controls Test allows you to manually check each
switch in the game.
NOTICE: Some switches (for example, TILT) may not be used with this game. Check
the wiring diagram and the mech setup items.
Activate each switch and the screen indication changes state. Release the switch and the indicator returns
to its previous condition. You can also test any combination of switches together.
The screen depicts
control names as they appear on the dash, gearshift, diagnostic switch bracket, etc.
One by one, operate each control. Simultaneously observe the screen. A single menu indication should
duplicate each state change in each control.
Use the Controls Test menu to verify crossed wires, intermittent conditions, and stuck switches.
Press and hold ABORT to test STEERING WHEEL force. During the test, restrain the wheel with one
hand. Watch the display. The force should increase to maximum and decrease to minimum. Change
directions and repeat the test.
Reset the pedal travel limits by pressing and holding TEST MODE. Press and release each pedal during
the test. Digital indicator numbers change each time the computer detects each pedal's new position. The
numbers turn green to indicate successful pedal calibration.
Advertisement
Table of Contents
