Table of Contents
Advertisement
Dollar Bill Validator
(Use MARS AE2411 -U3 U.L. Recognized currency changer)
Dollar bill validators or other currency acceptors may be installed in games that were manufactured with
the additional wiring connector. Switch off power to the game and unplug the A.C. line cord. Unlock the
coin door and swing it open. Read the coin door label for additional information.
Remove nuts, spacers, and cover plate from the door.
before mounting the unit. If the manufacturer has supplied an adapter plate, place it over the door cutout
at this time. Install spacers on threaded studs, then align the validator mounting holes with the studs and
seat the unit in the door opening. Install the nuts and tighten firmly. Attach the ground wire (green with
yellow stripe) lug to the door ground stud next to the hinge. Mate the wiring harnesses and press to fully
seat connectors. Route wires away from door edges and hinge. Inspect for proper bill chute alignment.
Be certain that the dollar bill validator is set to produce long output pulse tidfhs to avoid count errors.
Reverse these steps to remove a validator for service or replacement.
Plug in the line cord and turn on the game. Change the mechanism setup and pricing, then test known
good and bad bills to verify proper operation. Close and lock the coin door when the settings are correct.
Change switch settings or make adjustments
4-8
Advertisement
Table of Contents
