Table of Contents
Advertisement
The hasp bracket is in the spare parts bag. Remove four screws from the sides of the cabinet rear
door. Unlock and remove the rear door. Remove the two lock bracket nuts from inside the
cabinet, above the rear door opening. Slide the hasp onto the bolts so that it protrudes from the
hole in the back of the cabinet. Reinstall and tighten nuts.
Locate the lock plate at the top of the rear door. Remove the bolts and nuts from the lock plate.
Rotate the plate so that the slot will be above the door. Reinstall and tighten the bolts and nuts.
Now you can install an extra padlock to secure the rear door.
The main cabinet requires four swivel casters, one in each corner. Lay the cabinet on its back or
prop up one side to allow caster mounting. Orient a caster plate over the threaded studs. Align the
holes and seat the plate against the wood. Install a nut on each stud. Tighten each nut firmly.
The main cabinet requires four leg levelers, one in each corner. Install one nut onto each leveler.
Install one leveler and nut into the threaded hole in every ieveier piate. Do not tighten these nuts.
SWIVEL CASTER
LEVELER PLATE
LEVELER NUT
LEG LEVELER
CASTER NUT
VIEW OF CABINET ASSEMBLY v
The seat pedestal requires three swivel casters, one in each rear corner and one at the front
center. Lay the pedestal on its side or prop up one side. Orient a caster plate over the threaded
studs. Align the holes and seat the plate. Install a nut on each stud. Tighten each nut firmly.
The seat pedestal requires four leg levelers, one in each comer. Install one nut onto each leg
leveler. Install a leveler with its nut into the threaded hole in each leveler plate. Do not tighten nuts.
Roll the main cabinet to its intended location. Maintain clearance between the cabinet and walls,
drapes, other games, etc. Lower each leg leveler until the cabinet is stable and level. Adjust the
levelers to raise the wheels up off the floor. Distribute the cabinet's weight equally on each corner.
The factory ships the pedestal mounting rails bolted inside the main cabinet. Remove the two front
and two rear hex-head bolts that secure each rail. Pull the rails out, reverse them, and reinsert
them. Align the holes and reinstall the bolts.
Locate and expose the wiring harnesses inside the main cabinet and the seat pedestal. Roll the
pedestal section up to the front of the cabinet. Leave enough space to attach the wiring harness.
Mate each seat connector with its cabinet connector. Press the connectors firmly to seat contacts.
Align the pedestal opening with the rail ends. Slide the pedestal forward onto extended mounting
rails while guiding the wiring inside. Align the holes. Attach the pedestal using tamper-resistant
screws and large flat washers from the spare parts bag. Tighten the screws firmly.
ATTACHMENT OF CASTERS AND LEVELERS
l-6
LEVELER PLATE
SWIVEL CASTER
CASTER NUT
LEG LEVELER
BOTTOM VIEW OF SEAT ASEMBLY
LEVELER NUT
Advertisement
Table of Contents
