Maintenance And Battery Replacement - AJAX FireProtect User Manual

5. inside premises with the temperature and humidity beyond the range of
permissible limits;
6. closer than 1 m to the hub.
Autonomous Use of the Detector
The detector can be used autonomously, without connecting to a security
system.
1. Switch on the detector by pressing the on/off button for 3 seconds (the logo
will light up green for 1 second) and conduct the smoke test.
2. Select the optimal location of the detector following the recommendations
in the second part of the section
3. Install the detector as described in the section
In case of autonomous use, the detector noti es of the detected re/smoke with
the siren sound and light of the logo. To switch off the siren, press the logo
(there is a sensor button) or eliminate the cause of the actuated alarm.

Maintenance and Battery Replacement

Check the operational capability of the detector regularly. Clean the detector
body from dust, spider web, and other contaminants as they appear. Use soft
dry napkin suitable for tech equipment.
Do not use any substances containing alcohol, acetone, gasoline, and other
active solvents to clean the detector.
To a certain level, the detector ignores the dust in the smoke chamber. When the
chamber becomes too dusty, the detector noti es the user of the need to clean
it via the app (and beeps every minute and a half). Such maintenance is
compulsory for the detector to operate correctly.
How to clean up the smoke chamber
Pre-installed batteries ensure up to 4 years of autonomous operation. If the
batteries are discharged, the security system sends the respective noti cations
Selecting the location
Installation procedure
of this manual.
.