Selecting The Location; Installation Procedure - AJAX FireProtect User Manual

Selecting the Location

The location of the detector depends on its remoteness from the hub, and
obstacles hindering the radio signal transmission: walls, oors, large objects
inside the room.
Check the Jeweller signal level at the installation location
If the signal level is low (one bar), we cannot guarantee the stable operation of
the detector. Take all possible measures to improve the quality of the signal. At
least, move the detector: even a 20 cm shift can signi cantly improve the quality
of signal reception.
If the detector has low or unstable signal strength even after moving, use a ReX
radio signal range extender .
Install the detector at the ceiling in the highest point where hot air and smoke
are concentrated in case of re.
If there are any beams at the ceiling, protruding by 30 or more centimeters from
the ceiling level, install the detector between every two beams.
Where and how to install FireProtect Plus

Installation procedure

Before installing the detector, make sure that you have selected the optimal
location that follows the guidelines of this manual!