Connecting Speakers; Connecting The Speaker Cables - Marantz MODEL 30 Owner's Manual

Contents Connections

Connecting speakers

NOTE
0 Disconnect this unit's power plug from the power outlet before connecting the
speakers.
0 Connect so that the speaker cable core wires do not protrude from the speaker
terminal. The protection circuit may be activated if the core wires touch the rear
panel or if the + and - sides touch each other. ("Protection circuit" (v p. 40))
0 Never touch the speaker terminals while the power cord is connected. Doing so
could result in electric shock.
0 Use speakers with an impedance of 4 – 16 Ω/ohms.
Front panel Rear panel
Playback Settings
o Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and - (white)
polarities on the speakers being connected to this unit, and be sure to
connect the channels and polarities correctly.
1
2
3
Remote control 15
unit
Tips
Peel off about 3/8 inch (10 mm) of sheathing from the tip of
the speaker cable, then either twist the core wire tightly or
terminate it.
Turn the speaker terminal counterclockwise to loosen it.
Insert the speaker cable's core wire to the hilt into the
speaker terminal.
Index
Appendix