Connecting A Playback Device - Marantz MODEL 30 Owner's Manual

Contents Connections

Connecting a playback device

You can connect turntables, tuners, Blu-ray disc players, network audio players and CD players to this unit. Use the cartridge selector knob on the front
panel to set the phono equalizer on this unit according to the type of turntable cartridge to be connected. (v p. 8)
If you set this unit's input source to "PHONO" and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
Turntable Tuner
AUDIO
OUT
R
R
AUDIO
GND
OUT
R
CD TUNER
AUDIO IN
L
R
Front panel Rear panel
Playback
Network audio
Blu-ray disc
player
AUDIO
OUT
L R L
L R L
L R L
SPEAKERS
LINE-1 LINE-2 RECORDER RECORDER
AUDIO OUT PRE OUT POWER AMP IN
Remote control
unit
Settings
CD player
player
AUDIO AUDIO
OUT OUT
R L R L
R L R L
R L R L
17
Index
Tips
NOTE
0 The earth terminal (SIGNAL GND) of this unit is not for safety
grounding purposes. If this terminal is connected when there
is a lot of noise, the noise can be reduced. Note that
depending on the turntable, connecting the ground line may
have the reverse effect of increasing noise. In this case, it is
not necessary to connect the ground line.
0 The PHONO input terminals are equipped with a short pin-
plug. Remove this plug to connect a record player. Store the
removed short pin-plug in a safe place so as not to lose it.
Appendix