Stop Switch (Treadmill Only); Rf Coax Cable (Tv) - Precor P82 Service Manual

1 Introduction
P80 Armor Cable Installation
be attached to their respective connectors without being pinched, damaged or cause inter-
ference with controls.

Stop switch (treadmill only)

The Stop Switch assembly cable (treadmill only) should be routed through the lower right
corner of the armor, and connected to the 6 pin flat connector on the CPA board. The cable
will go through the center of the armor, out the bottom right side opening, then up to the con-
nector. Be sure to get the connector onto the six pins correctly or the treadmill will not work.

RF coax cable (TV)

The RF Coax cable should be routed down below the tuner, and out the right bottom side of
the armor. This is easier if you straighten the cable and gently push it through the center of the
armor, in the direction as shown. Use your finger to guide the cable out the bottom right side
opening and feed about 10 inches through.
(Undefined variable: ProductTemplate.ServiceManualTitle) 12