Precor P82 Service Manual page 24

software.
Standard, P10, and P30 Consoles
To access the service software:
Press either the STOP, PAUSE, or RESET key.
l
Sequentially type in the service access code using the numeric keypad.
l
NOTE: The access code must be correctly and quickly entered or the process will abort.
If the process is aborted, restart the process from the beginning.
P20 Consoles
To access the service software:
Press either the STOP, PAUSE, or RESET key.
l
Sequentially type in the service access code using the following control keys to rep-
l
resent an equivalent numeric value:
1 = Workouts key
5 = Enter key
6 = Up key
7 = Down key
NOTE: The access code must be correctly and quickly entered or the process will abort.
Restart the process from the beginning if this occurs.
P80 Consoles
To access the service software:
Make sure the P80 is set to the Welcome home page.
l
Press and continue holding down the PAUSE key while pressing the Volume and
l
Channel Up/Down keys in the following sequence ("X" pattern) to open the service soft-
ware login page:
Press/hold PAUSE while selecting CH Up > Vol Down > Vol Up > CH Down
NOTE: Keep the keypad entry interval to greater than 1 second between key presses.
Key press interval speed faster than 1 second may result in an unsuccessful login. .
Successful login will open the service access login page. Use the touch-screen keypad
l
to type in the service access code > Continue to open the functional mode software.
To access the Hardware Validation (5,1,7,6,5,7,6,1) diagnostic test page:
o
Select System Settings ( Settings page) >System Test ( System Settings page)
P82 Console
3 Standard Service Software
Accessing the Service Software
21