Precor P82 Service Manual page 17

1 Introduction
P80 Armor Cable Installation
Ethernet cable
The Ethernet cable should be routed through the center of the armor, and then through the
opening in the upper right side of the armor. The Ethernet cable connects to the upper. RJ45
type connector. The Ethernet cable will always be black and round.
The Data cable should be routed through the center of the armor, and then through the open-
ing in the upper right side of the armor. The Data cable attaches to the lower RJ45 type con-
nector. The data cable will always be grey and flat.
The Auto Stop cable (treadmill only) should be routed through the center of the armor, and
then through the upper left corner of the weldment. The connector will be a four pin keyed con-
nector.
The Power cable should be routed through the center of the armor, and then through the
upper left corner of the weldment. It is possible that when you are dressing the cables to pull
this connector back inside the weldment. Leave the connector on the side of the P80 as
shown, as it might be necessary to access it for troubleshooting.
(Undefined variable: ProductTemplate.ServiceManualTitle) 14