Shure MXA310 Manual page 55

Get Error Events (firmware > v2.0)
Command String:
< GET LAST_ERROR_EVENT >
MXA310 Response:
< REP LAST_ERROR_EVENT {yyyyy} >
Get Low Cut Filter (firmware > v2.0)
Command String:
< GET LOW_CUT_FILTER >
MXA310 Response:
< REP LOW_CUT_FILTER ON >
< REP LOW_CUT_FILTER OFF >
Set Low Cut Filter (firmware > v2.0)
Command String:
< SET LOW_CUT_FILTER ON >
< SET LOW_CUT_FILTER OFF >
< SET LOW_CUT_FILTER TOGGLE >
MXA310 Response:
< REP LOW_CUT_FILTER ON >
< REP LOW_CUT_FILTER OFF >
Get PEQ Filter Enable (firmware > v3.0)
Command String:
< GET xx PEQ yy >
MXA310 Response:
< REP xx PEQ yy ON >
< REP xx PEQ yy OFF >
Set PEQ Filter Enable (firmware > v3.0)
Where yyyy can be up to 128 char­
acters.
The MXA310 will respond with one
of these strings.
Send on of these commands to the
MXA310
The MXA310 will respond with one
of these strings.
Where xx is the PEQ block 01-04 on
mic channel. 5 is the PEQ on the
automix out channel. Where yy is
the PEQ filter 01­04 within the se­
lected block. 00 can be used for all
blocks or all filters.
Shure Incorporated
55/76