H3C S5120-HI Series Configuration Manual page 14

[SwitchB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on Switch C
<SwitchC> system-view
[SwitchC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
Configure the hosts.
3.
The default gateways for hosts A, B, and C are 1.1.2.3, 1.1.6.1 and 1.1.3.1, respectively. The configuration
procedure is not shown.
Display the configuration.
4.
# Display the IP routing table of Switch A.
[SwitchA] display ip routing-table
Routing Tables: Public
Destinations : 7
Destination/Mask
0.0.0.0/0
1.1.2.0/24
1.1.2.3/32
1.1.4.0/30
1.1.4.1/32
127.0.0.0/8
127.0.0.1/32
# Display the IP routing table of Switch B.
[SwitchB] display ip routing-table
Routing Tables: Public
Destinations : 10
Destination/Mask
1.1.2.0/24
1.1.3.0/24
1.1.4.0/30
1.1.4.2/32
1.1.5.4/30
1.1.5.5/32
127.0.0.0/8
127.0.0.1/32
1.1.6.0/24
1.1.6.1/32
# Use the ping command on Host B to check the reachability of Host A, assuming Windows XP runs on
the two hosts.
Routes : 7
Proto Pre Cost
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Routes : 10
Proto Pre Cost
Static 60 0
Static 60 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
7
NextHop Interface
1.1.4.2 Vlan500
1.1.2.3 Vlan300
127.0.0.1 InLoop0
1.1.4.1 Vlan500
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
NextHop Interface
1.1.4.1 Vlan500
1.1.5.6 Vlan600
1.1.4.2 Vlan500
127.0.0.1 InLoop0
1.1.5.5 Vlan600
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
1.1.6.1 Vlan100
127.0.0.1 InLoop0