Viking PA-250-IP Product Manual page 9

Typical Installation on SIP Based VoIP Phone System
VIKING
PA-250-IP
Viking
supplies
* Note: A PoE extender can be used for an additional 100 meters per extender. For longer
runs (up to 2 km / 1.2 miles) a ethernet to fiber media converter can be used.
** Network Port Settings
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full duplex
• Disable Spanning Tree Protocol (STP) or enable Portfast
• IBM compatible personal computer with:
Windows 7, 8 or 10
• Adobe Acrobat Reader 8 or higher
• PA-250-IP hardware
Download and install the programming software
1. Go to www.vikingelectronics.com and enter PA-250-IP in the search box
2. Click PA-250-IP in the search results
3. Scroll down the page to Downloads, click IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on setup Viking IP
Programming.exe
5. Follow the prompts on your screen to complete software installation
6. To start the Viking IP Programming application, click on the Viking IP Programming icon on your desk top.
The Main screen will appear, allowing the user to program any PA-250-IP connected to that LAN.
NOTE: PC must be connected to the same LAN as the PA-250-IP.
100m (328 ft) maximum*
10/100 Mbps
Maximum
Customer's
Responsibility
PC Requirements
PC Programming
SIP VoIP PBX
PC with
SIP Server
Software
**Optional
Switch / Hub
(Extends range of cable, keeps
1 Gbps network speed for other
equipment on network)
• Available LAN
• Ethernet cable (CAT5 minimum)
• 1 MB minimum free hard drive space for installation
• 16MB of free physical RAM
9
or
Internet
Optional Viking model RC-4A
Secure Remote Relay
Controller, see Programming
section 13 (DOD 582)