Security Code; Access Code - Viking PA-250-IP Product Manual

7. Security Code

The security code allows the user/installer to program the PA-250-IP with a PC and the required 'Viking IP Programming"
software. If the security code is left as default, the PC software won't require entering a security code when connecting
to the PA-250-IP. It is recommended that the factory set security code be changed. The security code can be set back
to default by holding the Reset button while the PA-250-IP powers up. See section D on page 7 for details. It can also
be defaulted by connecting to the unit with the IP Programming Software and clicking on the "Clear Adapter Settings"
button on the "Alarm / Firmware" tab. Factory Setting: 845464
NOTE: The security code must be 6 digits and cannot include a

8. Access Code

The Access Code is used with the "Auto Answer Secure" Inbound Call Mode to force inbound SIP page callers to dial
the Access Code before they can make a SIP page. When you call the PA-250-IP and the unit automatically answers
the call (see Programming section 18), you must dial the Access Code before you make a SIP page. Once a tenant has
entered the correct Access Code, 2 beeps are heard and the user can now page (see Operation section C). The Access
Code can be disabled if this basic security is not required. Factory Setting: 123456
NOTE: The Access Code can be 1 - 6 digits in length and cannot include a
Security Code.
9. Multicast Page Type
Multicast Page Type needs to be selected under the Amp Settings tab (see picture on page 16). Select Standard or
Polycom as the source of multicast paging. If Polycom is selected as the source, the Codes / Paging screen will change
to show its options (shown below). Factory Setting: Standard (shown on page 13)
or #.
Q
or # or match the numbers used for the
Q
14