Viking PA-250-IP Product Manual page 11

C. Configuring PA-250-IP VLAN Settings
Step 1 Click on the "VLAN" tab.
Step 2 Disable or enable VLAN tagging by setting the value of "VLAN Tagging".
Step 3 Set the VLAN tag ID by selecting an integer (1 to 4094) in "ID for all packets".
Set the Priority Code Point (PCP) value for all not SIP and RTP packets in the "PCP for all packets" input (0 is default, priorities are
Step 4
from low to high: 0, 1, 2, 3, 4, 5, 6, 7). Set the "PCP for SIP packets" (3 is default). Set the "PCP for RTP packets" (5 is default).
D. Manually Resetting the Security Code to Enter Programming
NOTE: This procedure will not erase a username and password used to access the PA-250-IP program mode. Only the security code is set to default.
Step 1 Power down the PA-250-IP by disconnecting the power cord.
Step 2 Press and hold the Reset button, then reconnect the power cord.
Continue to hold the Reset button until you hear 2 beeps, (approximately 6 seconds). Then release the button. The Status LED will
Step 3
remain off for the first 3 seconds, flash slowly for 3 seconds then fast flash (after 2 beeps), indicating when to release button.
Step 4 The security code is now reset to 845464 (factory default).
Step 5 You can now enter programming by following the steps in section A.
E. Manually Resetting All Network Parameters to Factory Default
NOTE: This procedure will erase a username and password that are used to access the PA-250-IP program mode.
Step 1 Power down the PA-250-IP by disconnecting the power cord.
Step 2 Press and hold the Reset button, then reconnect the power cord.
Continue to hold t he Reset button until you hear 2 beeps, (approximately 6 seconds). Continue to hold Reset button until you hear 4
Step 3 more beeps, (approximately 6 seconds later), then release the button. The Status LED will remain off for the first 3 seconds, flash
slowly for 3 seconds (2 beeps), fast flash for 6 seconds (4 beeps), then light steady indicating when to release button.
Step 4 You can now enter programming by following the steps in section A.
11