Adding A Pullback With A15I-Rigbar - L-Acoustics A15i Series Owner's Manual

Adding a pullback with A15i-RIGBAR

Type of deployment
Rigging accessories
Additional accessories
Min number of operators
Risk of falling objects
Verify that no unattached items remain on the product or assembly.
Secondary safety
Use available holes on the rigging accessories to implement a secondary safety.
Assembly
Procedure
1. Prepare a vertical array as described in
A15i-RIGBAR (p.65).
2. Raise the array until the bottom enclosure is accessible.
3. Remove the screw from the bottom rear hole of the bottom enclosure on each side.
4. Secure A15i-RIGBAR at the bottom rear of the bottom enclosure.
A15i owner's manual (EN) version 1.0
own array with pullback
A15i-RIGBAR
1 x Ø12 mm shackle WLL 1 t (provided)
M6x40 screws (provided)
M6x18 rigging screws (provided)
T30 Torx bit
1
Flying a vertical array with A15i-BUMP
Rigging procedures
(p.53) or Flying a vertical array with
67