Adding A Pullback With L2-Rigbar - L-Acoustics L Series Owner's Manual

Rigging procedures

Adding a pullback with L2-RIGBAR

Type of deployment
Rigging accessories
Min number of operators
Horizontal arrays
Do not raise the rear pickup point above the front pickup point.
Pickup points must be aligned with the linking points.
The chains must be as vertical as possible.
With L2-RIGBAR on top
Prerequisite
The array is completed and secured under L2-
BUMP with L2-BAR or
another L2-RIGBAR
Procedure
1. Secure L2-RIGBAR on the bottom enclosure using the ball-locking pins.
2. Secure a Ø19 mm shackles WLL 3.25 t to L2-RIGBAR and lift with an additional motor.
72
own array
L2-RIGBAR
2 Ø19 mm shackles WLL 3.25 t
2
With L2-BUMP and L2-BAR on top
See Flying an L2/L2D array with L2-BUMP and L2-BAR
Flying an L2/L2D array with L2-RIGBAR
(p.60) or
(p.70).
L2 owner's manual (EN) version 2.0