PRESSER BAR HEIGHT
The distance between the bottom of the presser foot in up position and the needle plate should be 6.0 mm.
1. Remove the face plate and needle.
2. Lower the feed dog below the needle plate.
Place 6.0 mm thick block under the presser foot and lower the presser foot lifter.
3. Loosen the hexagonal socket screw. Raise the presser foot lifter and tighten the setscrew firmly.
Attach the needle and face plate.
NOTE:
Make sure that the presser foot should be parallel to the feed dog slots in the needle plate.
Hexagonal socket screw
Zigzag foot (A)
Needle plate
Block
MECHANICAL ADJUSTMENT
6.0 mm
Feed dog
Presser foot lifter
Feed dog slots
8
Presser foot should be parallel
to the feed dog slots.