Feed Dog Height - ELNA Elnita ec 30 Service Manual

MECHANICAL ADJUSTMENT

FEED DOG HEIGHT

The highest position of the feed dog should be 0.80 to 0.95 mm from the surface of the needle plate.
To check:
1. Lower the presser foot.
2. Turn the handwheel toward you to raise the feed dog at its highest position.
The distance between the feed dog and the upper surface of the needle plate should be 0.80 to 0.95 mm.
If it is not in the range, adjust as follows.
To adjust:
3. Loosen the screw A.
4. Turn the handwheel to bring the feed dog to its highest position.
5. If the feed dog height is lower than 0.80 mm: turn adjusting screw B in the direction of C.
6. If the feed dog height is heigher than 0.95 mm: turn the adjusting screw B in the direction of D.
7. Tighten the screw A
Upper surface of the needle plate
0.80 to 0.95 mm
C D
A
B
13