Disassembling And Assembling - Porsche 924 Workshop Manual

Fuel Mixture
DISASSEMBLING AND ASSEMBLING MIX TURE CONTRO L UN IT
REMOVING AND INSTALLING SENSOR
PLATE
Removing
1 . Remove mixture control unit .
2 . Using vise jaw protectors, clamp mixture
control unit in vise . Clamp vertically at
bend on narrow part of operating lever.
3 . Loosen sensor plate mounting bolt and remove
sensor plate.
In sta lling
..
)
...
1 . Clamp mixture' control unit horizontally .
Coat sen,sor plate mounting screw with "Loctite"
or equivalent . Place new and/or absolutely
level sensor plate in cent er of operating lever
and tighten serew slightly by hand.
2 . Measure gap between sensor plate and venturi.
There must be an even gap of about 0 . 10 mm
(0 . 004 in . ) around the sensor plate.
Printed in Germany
Disassembling and Assembling Mixture Control Unit
25
25 - 15